| dc.description.abstract | A substantial raise in recuperator effectiveness has been established in the past by improving the fabricating and joining configurations regarding the manufacturing of compact recuperators. Further advancement of state-of-the-art recuperators requires providing for increased temperatures and pressures. 1bis can only be achieved by incorporating high temperature materials into the recuperator design. Although many high temperature materials have been identified in past research, less of these can be utilized in new concepts due to difficulties regarding fabricating and joining. However recently, in an independent study, a tungsten-copper alloy was identified through detailed
material selection methods as a suitable material for high temperature applications. The validity of tungsten-copper regarding fabricating and joining, to establish a leak tight structure still needs to be demonstrated. The aim of the study is to carry out a comprehensive review of existing recuperator
technologies and design methodologies as well as to investigate the manufacturability of tungsten-copper for use in a recuperator design of limited size. More specifically, the objectives entail the following: (1) The comprehensive review of existing recuperator technologies and recuperator design methodologies, (2) The design and fabrication of a recuperator of limited size using tungsten-copper as a heat transfer material and (3) The determination of the feasibility of fabrication of the design and the applicability of the selected W -eu alloy in the design. The fabrication technique that is presented in the design entailed the use of 2.Irm tungsten carbide drill bits to machine the correct recuperator profile, while the recuperator unit was joined by utilizing a mechanical fastening system. Although diffusion bonding was initially identified as the ideal joining technique for the recuperator of this research, restrictions and limitations relating to the use of diffusion bonding has lead to the
identification of a fastening system as the technique used. Evaluation of the fabricated recuperator revealed that several factors were outside the initially specified values, inter alia the flatness tolerance of recuperator plate geometries and machined slots precision. These factors contributed to a leaking recuperator structure when tested. The most likely contributing factors for the latter relate to non-conforming tolerances achieved in the fabricated design, residual stresses induced by the machining process as well as design
issues relating to the recuperator plate geometries. The design and fabrication of a recuperator of limited size using tungsten-copper as a heat transfer material, requires re-evaluation. Similar work will ensure a design of a high
quality when provision is made for advanced surface finishing of machined parts (notably the recuperator plate geometries), slight modifications to the design as well as stress relieving of machined components for the purpose of eliminating any residual stresses
that might be present. | |
